Journeyman X50 Setup

OnefinityCNC (Onefinity Support) December 21, 2021, 6:07pm 50

The stepper motors have current run to them when idle. This is idle holding current.

3 Likes

Stepper motors humming

Topic		Replies	Views
Journeyman Table	32	3393	May 24, 2024
Thoughts on my table design? Machine Setups	24	3029	October 10, 2022
1st post. Size matters and vertical clamping for finger joints & tenons	5	2230	January 14, 2023
Minimum table size journeyman Wasteboard	12	4087	October 22, 2022
Newbie with questions	14	1121	June 15, 2022