JTech laser movements

Accessories J Tech Laser
1

I’m
Having an issue where my JTech 7 w laser is making lines in a design when it moves from one location to another. These lines are the transverse lines. I’ve never had this issue before. It’s as if the laser is not powering off while moving from one starting point to another. I have attached a photo of the issue.

Any thoughts.

image
image1576×2100 1.26 MB

2

Did you ever figure this out? I’m having the same issue

3

Usually this is a symptom of the wrong post processor used

1 Like
4

Might be a problem with Masso 5.10beta–it went away when I reverted back to ver 5.09m (same Post processor)

1 Like