Trying to figure out why the laser engraving is off.
First toolpath is a layout for the wooden coins I’m making where to place them so can laser the pattern, box 5.25" x 7". This is cut on the lines.
Switching to a new file that just has the 5.25" x 7“ template.
Will run the toolpath for the first side of the coins. Now set the X and Y at the lower left corner of the box. I put the coins down within each of the circles and zero for Z.
But what I get is the toolpaths are off, shifted to the right.
I see no offset or anything to show why.
Jtech 7w laser with the VCarve Pro 11.554 with the laser module.