Masso Can Surface Your spoilboard! (Built in Routine/Wizard)

I used this and it worked really well!

It is an easy way to surface any wood. Just remember the +/- 1/2 * bit-width and you can surface any material. I just did an old plank of hardwood with great results.

I eyeballed the X-Y and zeroed it. Then used 80g paper for Z height. As the wood was very uneven I did the Z height at the HIGHEST point of the wood and then took of 15mm (yes it was wonky.

End result was a nice Valentines gift for my wife :slight_smile:

1 Like

So, Am I reading this right? Does that mean if I were to cut a full sheet of mdf spoilboard to cut make it 49"x49" and center it? ???