I hope with introduction of the Elite Series this not spell dooms day for the original series software. I’ve enjoyed using my Woodworker X35 and hope to see much better software down the road. The software that runs the machine (Ver. 1.2.1) is very basic but it works. As it is right now, if you are carving a project and the power goes out you’re in no mans land, this is really bad on a long carve.
I was just thinking out loud.
1 Like
It doesn’t. We’ve stated this many times. The x-35 is a more than capable machine for most jobs and the firmware team is still developing for it.
1 Like