I just set up the new machine and updated the firm ware. I cut a 32.5” x 32.5” MDF spoil board and centered it in the machine, 1” setback from the front of the Y gantry edge. After homing I place the touch probe on the corner of the waste board, center a 1/4 bit a couple of mm over the probe and h…

Maybe it’s the size of the waste board at 32.5"? I’ll go cut the spoil board down to 32.25 and try again.

Is the file set for xy zero center or bottom left? Check it’s not center.

I only have the onefinity test file in the drop down. I just cut the waste board down to 32” and I think it’s working. It slammed home a little hard after the probe, but I didn’t have any errors. Going to try to flatten the wasteboard and see what happens.

My companion software will allow you to place your touch plate normally (Left Front Corner) and have a resulting Origin (XYZ Zero located anywhere your spindle can reach. This also includes zeroing to the center of a circle. You can also use the touch plate on the right corner and have a right front…

Ryan, Is the file your trying to cut set for zero in the center of the board or the bottom left for xy zero in the program, not on the machine?

I’m not even cutting a file yet. The file I will be cutting starts at the lower left, which is why I’m attempting to use the touch probe in the lower left corner. I’m just following the videos I’ve seen and doing a very small number of steps before hitting an issue. What I’m attempting to do is: …

If your cutting the maximum extremes, you can’t use the touch probe because after it probes it will jog the bit to the front left…but since your probing the extreme there is no room for it to return to the front left. Try zeroing without the probe.

I am having the same issue. This was helpful.

I have found it extremely helpful to have a full size wasteboard, home x and y, set up the laser and print a grid of 10mm lines for y and x. I now know where every 10mm crossing is on my wasteboard which makes everything so easy to line up. Now you can pick, say the 200x mm line crossing the 200 y m…

[OF wasteboard] @ Ryan You said you set back 1" from the front edge. I’m a newbe also. If you look at the fine line on my spoil board it is the limit of my machine which is about 1 3/16 (+/-) from the edge of the Y foot. You are asking the machine to move past its limit. I have the spoil board top…

Please Help! X Axis Position is less than minimum error

Original/PRO Series (Buildbotics) (Gen 1)

OnefinityCNC (Onefinity CNC Official ✅) March 22, 2021, 11:25pm 18

Topic		Replies	Views
Prob issue not sure what is going on Original/PRO Series (Buildbotics) (Gen 1)	23	846	August 20, 2023
Trouble with a wasteboard setup Troubleshooting (X35/X50)	14	1101	March 16, 2022
Z axis position issue less than minimum Touch Probe	2	1812	March 1, 2021
Error Y Axis -- Minimum soft Limit Original/PRO Series (Buildbotics) (Gen 1)	25	4751	July 7, 2021
Problems with probing :: EROR: Y axis position -6.708mm is less than minimum soft limit 0mm	5	1809	March 24, 2022

Please Help! X Axis Position is less than minimum error

Related topics