I am having problems with the Vetric Laser driver. For some reason, the laser is not turning off between letters on a engrave so I get cutter path lines between the letters. Any suggestions on a solution? Also, tried a photoengrave with several iterations on power and speed and all I get is a soli…

[image] here are the settings that i just added … did not affect the laser …when i run the engrave routine it still burns the cutter path.

Are you using our vectric laser laser post processor?

Yes, VCarve 10.57 with the Vetric Laser Module and the OneFinity Laser Post Processor?

I restarted the controller to no avail … the laser is still burning the tool path between the engraved letters

[image] OnefinityCNC: Are you using our vectric laser laser post processor? I can’t find a Onefinity Laser PP on Vectric’s site. Is there one posted here that I haven’t found? Sorry, been looking everywhere.

the post processors are here [image] Jtech Laser Post Processors for Vectric (Download Links Included) (Old thread, built into Vectric 11.0 and beyond) Post Processors (Official) If you are running Vectric 11 or newer, these are built into Vectic and you do not need to dow…

send the vectric file to us at support@onefinitycnc.com and we’ll try it on our end. The settings you’ve shown look correct.

Problems with Vetric Laser Driver

Original/PRO Series (Buildbotics) (Gen 1) Troubleshooting (X35/X50)

OnefinityCNC (Onefinity CNC Official ✅) December 6, 2020, 3:56am 20

Topic		Replies	Views
Vectric Laser Module or Lightburn or? J Tech Laser	32	8469	March 20, 2023
Help with vcarve pro & jtech 7w laser J Tech Laser	14	2872	March 11, 2021
Vcarve pro and onefinity post processor J Tech Laser	5	2431	December 29, 2021
Laser works in manual mode, won't fire when processing Gcode J Tech Laser	22	4536	July 21, 2022
Jtech 14w Laser Not burning dark enough J Tech Laser	6	1510	October 22, 2022

Problems with Vetric Laser Driver

Related topics