Outdated. Lastest firmware here: [image] RealTime Redline Controller Firmware 1.4.6 (3/1/26) (Latest) Latest Firmware (Updated 3/1/26) 1.4.6 Firmware is now available for all Redline HMI controlled machines! Download Now: Downloads - RealTime CNC Redline Ra…

Did it change to where the Rotary Probe icon only appears when the rotary is connected? It doesn’t show up after the update.

Correct. Rotary only shows up if rotary is connected

I just wanted to check in on this… Since updating, I’ve had various issues that weren’t present before: The macro not holding. For example, I’ll set my G56 macro, run the job, it finishes, then I move the spindle out of the way to inspect before I pull it off. When I go to start the same job, not…

I had to go back the previous version to get things working right this was my problem…… Running the same projects, same toolpaths as I had before, but all of a sudden my finishing passes aren’t completing over the material. There’s still material left from my 3D raster roughing pass. This hasn’t hap…

@BarkingBladeDesignCo @cyberlynx1 Im testing the new firmware released last night version 1.1.3.8 found on my loosing steps topic. I’ll give an update on that post in less than an hour with the initial 50min test run.

I updated yesterday to 1.2.2 and have an issue where a couple jobs stopped midway had to reset and start over then it ran to completion. Had an issue where when the job ended I was unable to click ok to acknowledge program complete had to power off to clear

That has also happened to me multiple times. It’s like the touchscreen goes wonky.

Did you notice if the arrow wasn’t where your finger was? When i first got setup and surfaced my spoil board there was dust that got on the screen and that was happening to me at least. My alternative which might help you was plugging in a mouse to use the screen. Now i just keep an old one by the …

[image] BuilderBro: Had an issue where when the job ended I was unable to click ok to acknowledge program complete had to power off to clear That’s probably not new. It happens to me everyday with the production firmware. I just take a picture of the coordinate settings before every job so I …

I updated to the new beta 1.3.8 and ran 4 - 3d carves of 2.5 hours total without the previous issues of being unable to acknowledge program end and all ran to successful end. Hoping this fix holds. Thanks to OF support

RealTime Redline Controller Firmware 1.2.2 (12/2025) (Outdated)

Firmware RealTime CNC (Redline HMI) Outdated Firmware

OnefinityCNC (Onefinity CNC Official ✅) March 1, 2026, 7:06pm 17

Latest firmware:

Topic		Replies	Views
RealTime Redline Controller Firmware 1.4.9 (3/5/26) (Outdated) Outdated Firmware	7	305	March 30, 2026
RealTime Redline Controller Firmware 1.4.6 (3/1/26) (outdated)) Outdated Firmware	13	289	March 5, 2026
RealTime Redline Controller Firmware 1.4.18 (3/29/26) (Latest) Latest Firmware	0	188	March 30, 2026
Potential bug in redline version 1.3.1 (solved 1.4.9) Bugs	4	113	March 30, 2026
Potential bug related to restore Feature Request	3	70	March 30, 2026

RealTime Redline Controller Firmware 1.2.2 (12/2025) (Outdated)

Related topics