Tool Enable Doesn't Work With Huanyang VFD

[Aiph5u (Aiph5u (not affiliated with Onefinity))]

Hey Branden,

@WildMtnCraftworks

I may look into this more in the future, but I think I’ve settled on using L1 for now.

You are using the Onefinity’s Controller’s Load-1 Output. I just read what rickyacruz wrote:

@rickyacruz

Lastly, be cautious when using the Breakout Board Pin 1,2 (load 1 and Load2) or even the Terminal for PWM, as it’s capacity is limited to max 25MilliAmp only or even less so check your SSR or relays power draw before using one (most SSR draws about 8milliAmp) but checking will prevent damage to the Controller and RasberryPi.