Good afternoon all, I finally got around to loading in the new 5.06, Looking for some advice now. After rebooting the controller to finalize the update the screen is sideways, I no longer have a keyboard to enter the password to access the settings. On the screen it says the system is corrupted and all settings are back to basic defaults. What do I do now, do I have to go buy a wired keyboard to gain access to the settings now?

[image] Elite Series Masso Default Machine Settings Masso Default Configuration FAQ Elite Series Masso Machine Settings: (updated: 11/3/25) Part 1, 2, and 3 must be done in order. :one:Part 1: Firmware Before performing the two steps below, ensure the Masso firmware is 5.13 or later (Click Here to learn how to update your firmware, which is different than the below config reset) :down_arrow:Watch the video below to learn how to update the firmware of the Masso Controller down_arrow [Load software on your MASSO Touch - MASSO Top Tip 6] Loading these settings w…

That’s great, thanks for the quick response. But, did you read my whole post? I can not enter the settings without entering a password. Normally I hit enter on the digital keyboard, the problem is I no longer have a digital keyboard…

I figured that, was just hoping for an immediate solution. Thank you.

So the machine is back alive… now my question is, how do I upgrade to the 5.06 if the version in My Masso Worshop just bricks it back to raw basics. Is there a Onefinity version of the update? Do I have to go through and change all the parameters?

I loaded in the new 5.07 and the controller still says it’s running 5.03?

Troubles updating Masso Controller

Elite Series (Masso & Redline) (Gen 1) Controller (MASSO) Discussion

OnefinityCNC (Onefinity CNC Official ✅) February 25, 2024, 10:06pm 2

Topic		Replies	Views
Elite Series Masso Default Machine Settings Masso Default Configuration FAQ	0	13627	December 16, 2022
MASSO 5.07 released Controller (MASSO) Discussion	54	2249	June 4, 2024
Installing Masso G3 Update Controller (MASSO) Discussion	1	589	January 9, 2024
Ok where do I download Masso 5.10? Controller (MASSO) Discussion	9	566	June 16, 2025
From 5.07 to 5.13 then back to 5.10... all out of wack Troubleshooting (Elite Series)	12	395	December 23, 2025

Troubles updating Masso Controller

Related topics