HI All Has anybody got a digital file or dimensions of the following, I would like to make a cover to protect the cables Thanks in advance Dave [IMG_2767]

Onefinity response in another post. [image] Machine Dimensions Machines (Original/PRO) [Onefinity-Machinist-Dimensions] Sorry, here’s the dimensions for the Woodworker… [image] Machine Dimensions Machines (Original/PRO) [Onefinity-Woodworker-Dimensions]

Thanks for that info, I’m after the dimensions, widths , heights etc of the foot itself, i.e. end elevation Cheers Dave

How are you planning to make the cover? 3D print? There’s plenty of plans available or premade on Etsy.

Hey Dave, [image] Buddy: I would like to make a cover to protect the cables one like this? onefinity wire cover onefinity cable cover

I don’t have access to a 3D printer and was thinking of cutting something out of multiple pieces of ply and gluing them together Regards Dave

Hey Dave, [image] Buddy: was thinking of cutting something out of multiple pieces of ply and gluing them together I like that you want to make them from wood. Less plastic! :slight_smile: If you had a cnc machine you could also mill one :wink: Unfortunately I did not find the time to make these measurements yet, but Bill @Machinist makes very nice plans, on this one, there wasn’t much that was missing and that he would have measured the holes of the rails. Perhaps he has a plan of the whole foot cross section? [image] Aluminum Extrusion Table red_question_markUncategorized Here’s a document I created for my Machinist, and you just add 16" for the Woodworker. These dimensions worked perfectly for my base. MACHINIST FOOTPRINT.pdf (51.7 KB) Thank Bill @Machinist for this [MACHINIST_FOOTPRINT__Machinist_BB__Foot_section_only] (excerpt from a file from Bill that I downloaded once a while ago))

Hey Thanks for the prompt replies, the dimensions I’m after are those which would allow me to replicate the profile of the extrusion, not the dimensions of where the feet are located etc. i.e. the dimensions, as the picture shows the foot (extrusion) Sorry for misleading before. Rgards Dave

Here you go, this is the profile of the foot. Hole spacing dim’s are centered on the footprint. Let me know if you need anything else! [image]

Thanks for this Bill and for taking the time to send it to me, I think I’m misleading people, its the dimensions from the end view as per the picture I’m after, in my terminology this is a plan view Thanks anyway Dave

My apologies, @Buddy! I just glanced at @349iq2345’s post and assumed you were after the footprint. Hang tight and I’ll get you the profile. BTW, you are most definitely correct, that is the plan view. I didn’t find your OP misleading in the least.

Woodworker Foot Profile

Uncategorized

Ignoble December 30, 2021, 6:54pm 2

Onefinity response in another post.

Sorry, here’s the dimensions for the Woodworker…

Topic		Replies	Views
Can someone measure their Elite Foreman Feet for me? Uncategorized	4	1017	March 6, 2024
Machine Dimensions Original/PRO Series (Buildbotics) (Gen 1)	44	19913	May 6, 2022
Elite woodworker actual foot print Elite Series (Masso & Redline) (Gen 1)	6	653	January 16, 2024
Journeyman Pro Footprint Original/PRO Series (Buildbotics) (Gen 1)	1	595	December 13, 2023
Original Series Gen 1 Woodworker Spec Sheet and Footprint Layout x-35 Specs	0	4303	June 24, 2020

Woodworker Foot Profile

Related topics