XYZ Probe issues

Hi everyone. I’ve not had to use this forum before because I’ve never really encountered any issues with my Woodworker machine until now. I’m setting up a file and doing my XYZ probe per usual and now encountering a host of “errors.” I’ve attached an image of the errors I am receiving. I’ve tried restarting and resetting things (cleaning the probe pieces and bit) and nothing works, so I’m hoping someone on here can help. Thanks!

Hello!
The warning is saying you are too far to the left by .3005 mm (super small!).
Try moving your material to the right about an inch, and reprobe.

Here’s more on the over/under warnings:

1 Like

Aha, this totally worked thank you so so much for the fast reply!

1 Like