I have been using a .25’ down cut end mill that has a cutting depth of 2" to do profile toolpath cut outs but wondering if I could use a .125" end mill with an 1/8" shank that only cuts 1" deep to do this. Anyone have any insight?

It works as long as you understand that a 2" length bit will obviously have more cut reach than the 1". You risk tool holder interference (router/spindle nut) if the depth of cut exceeds the 1" on the 1/8 bit.

The overall length of the 1/8" bit was 2.5" so I think I should have enough clearance if I am only cutting down 1.5". Thanks for your response

You might also get some rubbing on the shank above the cutting length. I’ve done this and seen that, but didn’t bother me much. Was observed on the tool and not the part in my case. As long as the tool isn’t super expensive, I think it’s worth a shot. Sounds like this may be a cost reduction effort …

I do a lot of cut outs that are 1.5" to 2" deep and using the .25" bit takes so much material and I have to screw the work piece down because it is so aggressive. I haven’t been able to find any .125" deep reach bits that cut that deep so I thought this option would work and be a little safer. Tha…

What’s your depth of cut?? How many passes are you taking to get through that thick of stock?

I am cutting a depth of 1.5" for this one with about 17 passes. I supposed I could go with more passes as well so it is taking a little less material.

Yeah - that seems pretty aggressive. I get my new bit tomorrow and will give it a try. I mostly cut black walnut and definitely see a difference in cutting end grain vs face grain as well.

I’m doing something similar but what I was really is a long reach into some pockets where 1/4" (even if it’s long) would be too wide to give me the detail I want. So I looked all over. Including this place: Link that has a huge selection but that is also well-organized. (Easy to search.). Howev…

Thanks for the insight! I will check out your links!

1.5" depth profile toolpath bit selection

Uncategorized

makerjace (Jace) January 12, 2023, 10:53pm 8

Did you see this? I found it pretty interesting. I haven’t done anything this aggressive on the 1F, but people are out there trying cool stuff!

Topic		Replies	Views
Deep 1.5 inch Cuts in Pine Original/PRO Series (Buildbotics) (Gen 1)	7	2210	May 20, 2021
What 1/8th inch endmill to use? Uncategorized	4	548	October 24, 2022
End mill lengths vs overall cut depth Uncategorized	7	186	May 14, 2026
Bit recommendation for going deep? Uncategorized	5	642	October 18, 2022
Deep Reach Bit Recommendation Uncategorized	8	1884	February 6, 2022

1.5" depth profile toolpath bit selection

Related topics