Just sharing a few little 3d test carves right off the OF Elite Foreman today.
Carve time about 60mins each.
Carve time about 60mins each.
4 Likes
Neat! What was your tooling and stepover?
1/4 EM roughing and Tapered EM .75mm finishing 10% stepover
2 Likes
Great job and only 60 minutes each. What’s next 
Just did this one ~ 4hours But lots and lots of details, no sanding, right off OF
No bit drops, EMI or disconnects. My Elite Foreman is dialed in. and using a water cooled spindle
my carves are so so quiet. Cut speed 18,000rpm feedrate 100 tip .5mm stepover 10%, wood poplar
3 Likes
Try using a Raster toolpath, youll avoid those triangle marks on your carvings.