Progress update on the Acorn build. Wow, just wow. The motion is so smooth and stepper noise is basically non existent. What a difference this upgrade has made. The use of the pendant style jog wheel is a dream compared to the joystick when edge finding parts and the ability to have movement in the…

Ohhh, NICE!!! I seriously considered one of those when looking, but ultimately ended up with the DDCS V3.1 & G540, which is a great combo.

Awesome, glad it’s been working well. After a vac table, new steppers are my next project, which might force me to update the drivers and controller… we’ll see.

@trlwoodworks To be honest, if you are planning an upgrade, the controller should be your starting point. Starting with the steppers is like putting the cart before the horse or like buying an expensive camera body but using a basic lens to bring in the light. Higher quality signal generation/motion…

@alldaysammyj , I just noticed this on the first pic. Are you running the 2 larger power supplies in parallel? Assume the small one is for the Acorn board. [image]

@Machinist yes the small one is for the Acorn and the two larger power supplies are providing power for 2 drives each. Power supply #1 is X,Y and #2 is Z,Y. They are 36 volt 400 watt 11 amp power supplies.

Hello, just finding out about Onefinity yesterday. I am a newbie, but wanting to get a cnc router with 4th axis. Have investigated the Centroid Acorn system (went from $300 to $330). It looks great, however am concerned I may get bogged down with putting different pieces together. My ultimate go…

Begs the question, is Onefinity going to make a 4th axis available?

Doubtful, as the Onefinity controller will not support a 4th axis.

I would continue to research what else is involved with opting out of the 1F controller, as it involves more than just attaching the acorn (or other controller - I am using a Masso G3). You will need to purchase other hardware, and set up wiring for homing sensors, etc… This will add cost, time, and…

Hey Bill, hey Larry, hey Tom, [image] Machinist: Doubtful, as the Onefinity controller will not support a 4th axis. I doubt Onefinity will make one available, but the accessory market is full of them . Regarding the ability of the Onefinity or the Buildbotics Controller to use the fourth ste…

Acorn Build-bench testing complete!

Aftermarket Controllers (Unsupported)

GregoryG (Greg Martinez) December 29, 2021, 10:36pm 17

It is possible with the one finity controller without running both wise to one motor but unattaching won the y-axis and using that for the rotary here is a link to a topic that this has been discussed

Topic		Replies	Views
Anyone using servo motors with custom controller?	19	2113	July 27, 2022
Alternative controller? Aftermarket Controllers (Unsupported)	4	300	April 4, 2025
The Acorn has landed! Aftermarket Controllers (Unsupported)	12	2842	November 30, 2023
Elite Series Rotary Suggestion from Onefinity - The Official Onefinity 4th Axis Rotary - The Revolution Onefinity Rotary 4th Axis 'The Revolution'	20	6570	October 22, 2024
Stay Tuned. BIG things are coming in November 2024 👀 Announcements	81	3919	November 28, 2024

Acorn Build-bench testing complete!

Related topics