Think you would only need to set Z 0 the first bit - one time, then just change the bits. Would work well if your first pass took off all / most of the material surface and you have nothing to Zero your next bit to? Wondering if anyone uses these? This comes with a tool to ensure the stops are a…

Anyone using these Speed setters?

makingmagick (Tony Armisto) December 9, 2020, 1:30pm 5

That is where I found out about them…
Here is a link to the video for others…

2 Likes

Bit positioning and changing during a job?

Topic		Replies	Views
Stop collars to speed up z zero checks Accessories	2	247	November 24, 2023
Not having luck with Harbor freight 1/4 Hss twist endmill bits?	4	682	October 22, 2022
New tool setter arrived - test results - NEW VIDEO Aftermarket Controllers (Advanced Users Only)	32	4859	November 30, 2023
Recommended Bit Set Tool Database Settings Machines (Original/PRO)	2	806	March 13, 2021
Speeds and IPM and feeds Troubleshooting (X35/X50)	10	1996	October 4, 2023