Brakeout board and relay wiring?

Just ordered from 1F the brakeout board, and a relay from Amazon. any one have a diagram/ information as to what cables/ wires are needed so the router, controller and dust colector will turn off when the cut is finished ?

1 Like

Thanks for the reply and information. Im new to all this so after the parts come in I will meet more help on the g code settings before I jack things up
Thanks again for the fast reply

You shouldn’t have to make any changes in your gcode. Pretty much all carving files have the spindle on off commands already included by default, even if you don’t have your spindle setup to use them.