Further to my zeroing question of last week, when I Home I get the following occurs: Makita goes up, Makita goes down, Estop is activated. Status for X, Y and Z is Unhomed, Z Toolpath is “Over”, X and Y are OK. If I Probe for X, Y and Z, it moves around but not the way its supposed to (I have done this successfully in the past so I know how it is supposed to act). Is something not set correctly? Is the probe or workpiece not positioned properly? Any help is appreciated.
(Sorry if this is a duplicate posting. I tried to post this query as a reply but I don’t think it went through. Still learning my way around the Forum) Thanks, Mark
1 Like
Most likely a wire issue:
Thank you for your prompt reply, Marcos. How do I check the firmware settings and what am I looking for?
Thanks,
Mark