Further to my zeroing question of last week, when I Home I get the following occurs: Makita goes up, Makita goes down, Estop is activated. Status for X, Y and Z is Unhomed, Z Toolpath is “Over”, X and Y are OK. If I Probe for X, Y and Z, it moves around but not the way its supposed to (I have done t…

Most likely a wire issue: [image] Troubleshooting: Rail is getting hung, stuck, grinding, or moving in opposite direction Troubleshooting Rail is getting hung/stuck/grinding. Special notes to read before following each step: A rail getting stuck/hung is typic…

Thank you for your prompt reply, Marcos. How do I check the firmware settings and what am I looking for? Thanks, Mark

Homing/Zeroing Problem

Original/PRO Series (Buildbotics) (Gen 1)

OnefinityCNC (Onefinity CNC Official ✅) May 10, 2024, 12:49pm 3

Most likely a wire issue:

Topic		Replies	Views
Help! Journeyman Homing issues Troubleshooting (X35/X50)	24	3258	February 26, 2022
Z-axis grinding and going up then down and triggering estop	1	124	January 13, 2025
Y axis not homing	6	920	February 17, 2021
Y rail and homing problems Original/PRO Series (Buildbotics) (Gen 1)	6	895	November 20, 2023
Machine cutting, everything stops. Resets X,Y,Z to zero and says the machine in not homed	7	668	February 25, 2023

Homing/Zeroing Problem

Related topics