Hi I am looking for some help. I just upgraded my X50 woodworker to an Elite Woodworker. the spindle ran fine in the build botics, and I have it running one the masso but there is something a miss. I do not have Rev wired. which I doubt i would ever use. But the problem is that I give it a m3 s120…

Huanyang spindle and VFD 800 watt on masso

Aiph5u ((not affiliated with Onefinity)) March 14, 2024, 12:27pm 4

Hey Marcel,

did you use the search function of this forum?

If so, did this or this not help?

Topic		Replies	Views
Vfd will not run any faster than 7200rpm even when set to 18,000rpm	10	169	October 28, 2024
Spindle running at half speed Troubleshooting (X35/X50)	31	6815	January 21, 2025
No 0-10V spindle voltage on the Masso Spindle/VFD (Aftermarket)	7	661	September 27, 2023
HY VFD Not Controlling Spindle (solved) Spindle/VFD (Aftermarket)	3	1288	October 3, 2023
RPM Range of VFDs Spindle/VFD (Aftermarket)	26	4192	September 27, 2023