HY VFD setup and program for water cooled spindle 110v

[CommunityUser5]

Hey Jay,

welcome to the forum!

@Grindingaway

So to get the dial to control the speed, what did you set?
I press run on my unit and the motor spins up to 400Hz and the dial does nothing

The answer is written there, above:

@CommunityUser5

set jumper J1 to “2-3” and set PD002 to “1” and PD070 to “1”. Then the potentiometer on the Front panel will control speed. But be aware that with these settings, the Onefinity CNC controller will not be able to control the speed by the g-code program or by entering speed commands in the MDI field.

@CommunityUser5