Joypad State On Redline Controller (FAQ)

[OnefinityCNC (Onefinity CNC Official ✅)]

Update 12/12/25

Joypad for Jogging

Joypad Controllers are partially integrated and work right out of the box.
While the joypad does work, it currently needs to be in “XBOX mode.”
We’ve found that unplugging and re-plugging the joypad dongle until “XBOX” mode registers (under the Joypad tab) enables movement controls. Sometimes, once it’s in this mode, you need to push ‘detect’.

This system will be refined in a future firmware update.

[L.M]

I’m guessing that XBOX mode is not indicative of being able to use a Xbox controller for the Joypad functionality?

It would seem that the only device that will work is 1F’s joypad? If that’s the case I don’t have an issue with that, just trying to get past my own assumptions.