Laser/router job process question

[rblur01 (Roger Treadway)]

Vectric Post Processors For 10.5 or older versions (Download Links Included)

7/21/2021: Vectric V11 is out now. The Onefinity machines and post processors are now included in the software and do not require being manually downloaded into the program! There is now a machine configuration management selection pop up box that allows you to select the Onefinity and the specific machine configuration you have. You should only need to download the below post processors if you are using V10.5 or below. PP UPDATED 12/16/2020 Here releases of the Post Processors for Vectric…

That post processor for the router

Jtech Laser Post Processors for Vectric (Download Links Included) (Old thread, built into Vectric 11.0 and beyond)

If you are running Vectric 11 or newer, these are built into Vectic and you do not need to download and install these. Updated 6/17/21 Version (2.0): Onefinity Laser (Inch) V2.pp (4.9 KB) Onefinity_Laser_mm_V2.pp (4.9 KB) Install these to use the Jtech Laser add on when using Vectric.

This post processor for the laser