I have a 2 sided 3D carve, with a roughing and finishing tool path. (as well as dowel holes) each toolpath is several hrs long (especially the finishing pass) I seem to remember a post where the OP was able to shut down the controller and restartat a later date. I understood this was between tool…

All I do is before power down, send the machine to my work offset (0,0 of the workpiece) and take a photo of the 1F webpage noting the absolute XYZ positions. Upon power up and after homing the machine, I issue the following: G90G0X123.45Y67.89Z3.14 which translates to: G90: Absolute mode G0: R…

Here’s another option to avoid stall homing repeatability issues. Face your stock for correct thickness / Z-height. Profile the front left corner of your stock using the machine. Make sure you actually get the edges to achieve a machined surface and establish a clean reference. Shift your C…

Long carving job with multiple tool paths

Original/PRO Series (Buildbotics) (Gen 1)

Mitch June 22, 2023, 9:54am 2

Hi Mike!
There are several post that come up when searching Keeping zero power down. @349iq2345’s reply in Pause during carve might be what you were seeking.

Topic		Replies	Views
Re-Starting a Carve after shutting down Original/PRO Series (Buildbotics) (Gen 1)	4	750	August 26, 2021
Restarting or trying to finish job Troubleshooting (X35/X50)	23	2764	January 6, 2022
Restarting a job mid way through	4	1064	May 13, 2022
Keeping zero position Original/PRO Series (Buildbotics) (Gen 1)	93	9992	February 2, 2024
Need advice/ help	5	1084	December 31, 2021

Long carving job with multiple tool paths

Related topics