Network direct cabling

[Aiph5u (Aiph5u (not affiliated with Onefinity))]

Hey Max,

@ONTB

Because the cable is attaché to a Wi-Fi router in Onefinity’s video

Well then you have bad luck. If there is a video with a WiFi router, then it is strictly forbidden to read and follow the text:

@onefinitycnc

Connecting your Onefinity CNC to a Computer/Laptop (no touchscreen present)
Please note: Before you start please make sure wifi is turned off on your computer/laptop (as you will be using an ethernet cable)

1. Turn off internal wifi on your computer/laptop.
2. Make sure that the emergency stop is disengaged/disabled
   2a. If this is a brand new machine you will need to turn the emergency stop to get it to “pop-up” out if it’s stored position during shipping
3. Connect up the included power cable to the 1F controller
4. Connect up an ethernet cable with one end plugged into the 1F controller and the other connected to a laptop
5. Turn on the power switch to the 1F controller and make sure the laptop is powered up to an available desktop view.
   5a. You should be able to visually see lights on the ethernet port of the 1F controller and laptop at this point.
6. Open up a web browser on the laptop and navigate to http://OneFinity.local
   Important note: Ensure WiFi is turned off in your laptop.
7. This should now provide local based access to your 1F allowing control without a touchscreen.

Good night!