Here is my problem. I’m trying to cut 1.125" circles from 0.2" Corian. The circles I’m ending up with are a little small, but relatively consistent along x and y (they end up at 1.122). When I measure them at 45 degrees to x and y I end up with 1.126 and 1.118 respectively. Does anyone have any idea…

Oblong Circles at 45 Degrees to X/Y Axis

Aiph5u (Aiph5u (not affiliated with Onefinity)) August 26, 2021, 6:57pm 4

Hey Kyle,

Agree; this has been discussed here the other day

1 Like

Topic		Replies	Views
Rotary Axis incorrect size of cuts Troubleshooting (X35/X50)	5	479	August 9, 2022
My X axis thinks it is longer than it is and my Y is short on carves	8	931	September 13, 2021
X and y different each time machine re-homes Troubleshooting (X35/X50)	1	305	September 24, 2022
Cut doesnt match tool paths Troubleshooting (X35/X50)	1	374	February 2, 2022
Y Axis not traveling all the way when doing first surface cut Machines (Original/PRO)	2	272	February 13, 2023