[IMG_0595] I get a yellow warning and then whein i click on it I get this message the Z Unit does not go all they way to the top when trying to home When i keep going and probe xyz it is ok but when i run g cone it give me and error and wont let me cut down to the top of the spoil board Can you…

Check cnc home and home of the CAM programme are the same. Check your Feed and clearance heights in the CAM programme. They sometime acculumate (e.g. Feed height is 5 mm above model height, clearance is 10mm above feed height etc)

thank you what is the maximum it should it be set to on my CAM programme ? does this look correct ? [Capture]

I get weird error messages, too. Not sure what the deal is (I was on 1.0.9, went to 1.1.1, then back to 1.0.9…errors on each firmware). zError1.pdf (22.8 MB) zError2.pdf (19.4 MB) zError3.pdf (24.9 MB) zError4.pdf (25.0 MB) I haven’t replaced my z-axis cord, yet. It’s a very intermittent prob…

I agree with “software bug”. Recently resurfaced wasteboard and cut a new grid with same programs used before. Got multiple over, under errors on all axis, that never happened before. My solution was to reposition all the axis and re-zero each of them, multiple times until the 1F was “happy”. Note: …

They are not big numbers. Do you have a really fat / deep piece of wood or a very long end mill or both?

:man_facepalming: So, just looking at that last picture… Position…Absolute…Offset 500…500.846…0.846 I think the only reasonable conclusion is that the machine was in G90 (absolute reference), rather than G91 (relative) mode. If it were in G90, then I commanded an absolute position of x=-495, wh…

Problem homing machine Z Axis

Original/PRO Series (Buildbotics) (Gen 1) Troubleshooting (X35/X50)

OnefinityCNC (Onefinity CNC Official ✅) January 24, 2023, 8:50pm 6

it’s not a software bug.

:Help! My Toolpath says 'Under' or 'Over"! (with videos)

Topic		Replies	Views
Z axis will not lower Troubleshooting (X35/X50)	8	868	May 25, 2022
Z axis homing issue Troubleshooting (X35/X50)	5	4210	September 28, 2021
"Y" & "X" will not home correctly Original/PRO Series (Buildbotics) (Gen 1)	10	1537	August 18, 2021
Z Axis greater than soft limit of 0 Original/PRO Series (Buildbotics) (Gen 1)	9	914	June 20, 2024
Z axis position error	11	2052	April 13, 2023

Problem homing machine Z Axis

Related topics