Problems with 1.2.1 flash update

[Aiph5u (Aiph5u (not affiliated with Onefinity))]

Hey Stacy,

@midwestcat25

2 problems

1. G codes files I send to the controller will not be recognized correctly. They will show up but they are way off.
   For example: one of my designs is a 4"x4" coaster 1/4 inch thick with a monogram design. When it loads up on the machine it looks extremely tall on the z axis and the it reads “will not fit on the z drive”. Also, there are 10 or so different toolpaths on this coaster. When it loads up all the toolpaths are separated far apart on the z axis separated in layers.
   These particular files that I’ve sent to the controller are the exact same files I used before the 1.2.1 update so I know for a fact this isn’t a software issue or a post processor issue. Everything was working fine before the 1.2.1 update.
   I’ve also reflashed and updated the controller multiple times with the same outcome.
   I’ve also tried beta version 2 and it does the exact same thing.
   At this point this machine cannot be cutting with this new update (1.2.1).
2. Probing XYZ can’t be done as well. When the controller asks you to touch your probe to your bit it will recognize but I can’t hit next because it is grayed out.
   However if I just want to probe z that works fine. I can hit next to continue.
   This is not a wiring problem or voltage problem.

If anybody is experiencing these same issues please let me know if you have found a solution.

You say the problems appear after you flashed with the onefinity-raspi-1.2.1.img.xz image, is that correct?

If so, could you please flash the SD card with onefinity-raspi-1.0.9.img.xz and report if the problems are gone then.

Howto:

• How to reflash the operating system on the Onefinity (Full SD card image)

By the way, the thread to report 1.2.1 firmware issues → is here! ←.