Right rail higher than the left

Hi I noticed my rails where not the same height, was surfacing my sacrificial board when I noticed first pass did not touch most of the left side that’s when I seen the gaps under the “linear motion shafts” I believe they are called, So I took I placed some flyers underneath both to gauge the difference, left side = .05 5 flyers right side = .18 in 20 flyers in picture



my question is what should I do leave it, raise left side to .18 in ?

It’s more likely your table is not 100% flat.

4 Likes

that appears to be possibly it, this is a new table, I converted from woodworker to journeyman, I’ll go over fasten ply more secure then report back thanks…