I turned on the Onefinity controller and it starts up with two dialog boxes (one homing dialog atop a simulating dialog box). Pressing the “OK” on the Home Machine dialog causes the dialog to disappear with no homing action. The dialog underneath seems to be stuck on [pnf] The rest of the UI is in…

Reflash the SD card. Somehow, non gcode has been injected into the controller. [image] How to reflash the operating system on the Onefinity BB controller (Full SD card image) Full SD Image There are times when you may have a file go corrupt or (advanced) users start poki…

Seems like disconnecting the camera from the controller box allows the controller box to boot normally.

I am in this same boat right now hopelessly stuck for hours. How did this get resolved?

For me it seems as though my attached 1080p webcam was causing problems. After disconnecting it, I no longer have this problem. Do you have a camera hooked up? You could try ssh’ing to the controller and poke around to see what files you have downloaded to the machine.

[image] How To Remove All Gcode Files Manually (Fix for stuck file) Troubleshooting How to remove all gcode files manually. This process is used for when you see a stuck file. In 99% of cases, a incompatible file was loaded (such as the design file) and not gcode. The c…

I don’t really think this is the problem in this case. My machine is just set up and it hasn’t actually cut anything or been loaded with another file. It’s still the default team onefinity file. Since removing the camera, I’ve not encountered any problems with starting up the machine. I can even air…

Definitely the camera, I couldn’t get it to boot without this issue for anything until I unplugged the camera. I’m running 1.0.8 so that may be the issue. I’m a little scared to make the update while I’ve got orders to fulfill, but I’ll try to make a note on this post if 1.0.9 resolves the issue whe…

Hey Kyle. I was browsing the forums for issues similar to yours and discovered a couple, one related to random disconnects associated with the camera and another related to random disconnects associated with the usb-cabled joystick controller (both of which boiling down to a usb-related issue). On…

FYI. I don’t have a camera, but I did unplug the joystick and that fixed it for me.

I am having the same problem. i never had a camera or wifi. reloading the firm where worked for a couple carves but the problem came back. I have tried new thumb drive but that didnt help

Removing the /var/lib/bbctrl/upload/ files worked. However, when CTRL+D took me back to the web page, I still had the dialog that said “Processing New File”. I went back to the command line and did sudo reboot -n When it came back up, all was well and back to normal. Thanks for the info on removin…

Stuck "Processing New File" on boot

Original/PRO Series (Buildbotics) (Gen 1) Troubleshooting (X35/X50)

OnefinityCNC (Onefinity CNC Official ✅) December 5, 2021, 6:08pm 5

Topic		Replies	Views
V1.3 Hit STOP in web interface, can't load a new file, I lose zero Troubleshooting (X35/X50)	10	874	December 17, 2023
Stuck Processing new File (solved, reflash sd) Original/PRO Series (Buildbotics) (Gen 1)	1	66	December 20, 2025
Strange file transfer Issue Original/PRO Series (Buildbotics) (Gen 1)	2	216	May 24, 2024
Stuck on Screen Popup Troubleshooting (X35/X50)	20	2220	September 12, 2021
Error 12c write failed Errno 5 input error	28	2634	June 29, 2022

Stuck "Processing New File" on boot

Related topics