This faq is used by support to determine if a wire or motor is damaged, and how to identify each one. WARNING: DO NOT UNPLUG OR PLUG ANY WIRES IN WHILE THE CONTROLLER IS ON! YOU WILL DAMGAGE YOUR MOTOR DRIVERS AND VOID THE WARRANTY! [WARNING Controller must be off be plug or unplugging cables] Y…

Support: How to determine if a wire or motor is damaged

OnefinityCNC (Onefinity Support) September 23, 2024, 7:42pm 2

Topic		Replies	Views
Onefinity Wiring Diagram Wires	0	2851	July 20, 2022
Motor Faults motor will not run Troubleshooting (X35/X50)	10	770	January 26, 2023
Z stepper motor not working stopped working Troubleshooting (X35/X50)	10	597	July 11, 2022
Z Stepper Motor Cable extension woes	2	810	September 15, 2022
Moving Y-axis plug Assembly	2	597	April 15, 2023