Tool Setter using a laptop with Redline Software

Accessories Touch Probe
1

Good day everyone.

I just got my Apprentice, which I ordered with the touch probe and tool setter and when setting up the Tool Setter I came to realize there’s a discrepancy between the HMI interface and the laptop’s interface.

In the instruction video they mention F3 and F1. While I’m aware the information shown on the F3 screen for the coordinates was in my laptop’s main screen, when they mention F1 to select Auto Tool Zero to enable it, and enable setter X position, same with Y position, I really haven’t seen that option in the laptop’s software. Pressing F1 on my keyboard doesn’t do anything either.

I’ve searched the forum, and online and I haven’t seen anyone talking about this. Is anyone aware of this or any other discrepancies between the Redline HMI and the computer’s software? And do I just skip this setter position in the laptop because is not available?

Thank you in advance for any information or sharing any page that has the information.

2

Tool setter setup is on the same page as the HMI
Here’s what it looks like.

tool setter
tool setter1725×1327 160 KB

3

Thank you for the answer. The interface is definitely different, or at least worded differently, but I was able to do it.

tool zero
tool zero1333×747 249 KB

4

You have a Masso controller, not a Redline. That explains why it looks different.