Hi All Does anyone know if there’s a video anywhere for tramming an 80mm spindle, searched on here and youtube but can’t find anything Thanks Dave

[image] Tramming issues on x50 80mm Troubleshooting (X35/X50) I have a Journeyman 50 wall mounted in a qcw frame with 2.2kw spindle. I laid out a wasteboard flattening file and ran it with 2" flattening bit the result was a ridge I could fully catch on fingernail and the …

HI Again, Thanks for the link, I’m ok with the theory behind the tramming tool, I wondered where the best place was to add shims etc. Would be great if the Onefinity guys had something the could share, perhaps already have and I’ve just missed it. Thanks again Dave

(407) Tramming your Onefinity and Laying out a gridline on your Spoilboard - YouTube

Depends on tram issue. I put folded layers of aluminium foil behind the zslider at the bottom. A bit of a pain should i need to change the slider height but i am anle to adjust the spindle in its clamp which is sufficient for my needs. There is a 1F video about adjusting the screws on the gantry …

Lots of folks miss the notion of having a flat/coplanar surface to tram to and spend a lot of time tramming to a not so coplanar/flat waste board. Tramming to the waste board can be an iterative process to get it completed. Here’s a video that shows how to get a good surface to begin with and the…

Thanks All for you valued support, Regards Dave

Are you out left to right or front to back? Left to right there is play in the z mount that will allow you to get it adjusted. Front to back you will either need spacers between the z plate and where it mounts top or bottom depending on which way its out, thats how I adjusted. What I didnt know at…

I’m not sure which way its out yet, as I’m still waiting for the Tram tool to arrive. I’ve looked at the adjustment for front to back, but wonder how people adjust left to right, if they are shimming where do they put the shims? Cheers Dave

Tramming 80mm Spindle

Uncategorized

makerjace (Jace) May 15, 2022, 12:39am 3

Topic		Replies	Views
Tramming issues on x50 80mm Troubleshooting (X35/X50)	3	849	February 24, 2022
Micro-tramming Adjustment? Elite Series (Masso & Redline) (Gen 1)	10	3360	July 31, 2024
Tramming the Router Troubleshooting (X35/X50)	119	22235	December 24, 2023
Squaring the spindle Troubleshooting (X35/X50)	3	906	April 18, 2022
Tramming Y Axis - Not understanding Uncategorized	32	2192	June 27, 2022

Tramming 80mm Spindle

Related topics