Every time I try to export a file from Vcarve to the controller, it does not recognize any file I try to send!! The controller will not read my thumb drive as well. Is there a way to reboot the controller back to factory settings? I just can’t figure out why nothing will work!! The only file I can u…

are you sure you’re loading gcode (.nc/.ngc) files and not vectric design(.crv) files? [image] File Format For Loading Files onto a USB stick (Buildbotics) USB This only applies to the buildbotics controller. If your going to use a usb stick to load your gcode files, mak…

Once you have completed your design in the drawing tab, you then go to the toolpaths tab to create the necessary toolpaths (profile/pocket/vcarve etc.) for your design. Preview the toolpaths you have created then if OK, generate each toolpath in a separate file (if you are using different bits) and …

@SteveyT As a thought, have you loaded the post processor for the OneFinity in your VCarve Pro software? I recall when I first started using VCarve, I was not using the right post processor.

Transferring Vcarve files not working!

Uncategorized

OnefinityCNC (Onefinity CNC Official ✅) October 12, 2021, 7:53pm 2

are you sure you’re loading gcode (.nc/.ngc) files and not vectric design(.crv) files?

Topic		Replies	Views
Toolpath files not recognized by network or USB Troubleshooting (X35/X50)	4	289	June 24, 2024
Files not loading Controller (Buildbotics) Discussion	17	3194	August 24, 2023
Unable to open files on flash drive Uncategorized	9	1692	August 30, 2021
File Format For Loading Files onto a USB stick (Buildbotics) Controller (Buildbotics) FAQ	0	7350	November 21, 2020
Wont read my project files Troubleshooting (X35/X50)	18	2777	July 8, 2022

Transferring Vcarve files not working!

Related topics