I just upgraded the firmware on my machine to the 1.1.1. I logged into the console via a web browser over WIFI ( http://192.168.4.110 ) from my lap top. I loaded a job via the browser from my lap top after Probing XYZ from the monitor of the CNC machine. Notice the difference in the Toolpath. On t…

Interesting, that makes sense technically. I was curious because when I load a new file via my lap top, the interface on the monitor flashes and then shows that same file that I just loaded via the laptop so it seemed they were somewhat in sync. Also, any movements I do via the lap top also show o…

Web Interface vs Panel are Different

Original/PRO Series (Buildbotics) (Gen 1) Troubleshooting (X35/X50)

OnefinityCNC (Onefinity CNC Official ✅) September 15, 2022, 8:50pm 2

Normal, they are never in sync as they are technically separate instances of the interface.

Interaction among multiple ethernet computers and a USB monitor (original BB controller)

Topic		Replies	Views
Interaction among multiple ethernet computers and a USB monitor (original BB controller) Original/PRO Series (Buildbotics) (Gen 1)	13	545	March 22, 2024
Version 1.3 challenge (not solved)	9	476	November 26, 2023
Onefinity interface question Original/PRO Series (Buildbotics) (Gen 1)	6	1011	June 17, 2021
Visualize pathview on console Troubleshooting (X35/X50)	7	842	March 8, 2021
Now, I'm just really frustrated with setup	14	1015	June 26, 2022

Web Interface vs Panel are Different

Related topics