Woodworker 32 firmware (solved via link)

[UBU (Yvan brousseau)]

Hello, I upgrated my CNC with the heavy Z 20 Slider. I update the Firmware to 1.2.1 version. This version doesn’t give me the choice of Woodworker X-32. Only X35 or X50.

Also, I can not change the Z slider at Z-20 Heavy Duty

How can I have the good updated firmware for Woodworker 32x32 with Z Slider 20? Where can I download it pls?

Thank you

[OnefinityCNC (Onefinity Support)]

From the faq that was sent in the support ticket:

Installing the Z-20 Heavy Duty Z Slider (configuring the software)

After physically installing your new Z-20 z slider, you will now need to change the software to match the new hardware in order for it to work correctly. This FAQ only applies to NON-Elite machines. First, firmware 1.2.1 (or later) must be installed on your controller. Click the blue link below to download the latest firmware 1. After 1.2.1 (or later) is installed from the blue link above, Go to the flyout menu (three horizontal lines in the upper left) [1] 2. Click on “Admin”, “General” …