I normally use the x and y settings by hoovering over the edge of the workpiece. The Z I use the automatic settings with the probe block. Now I tried the XYZ auto zeroing with the block.
By triyng to enter the values in the settings page chapter “Probe block width”, and “Probe block length”, there is no indication what is x and whot is y. Besides this while probing,I never been asked the tool diameter. Do I overlook something?
Hey Andreas,
in a right-hand cartesian coordinate system as used in 3D CNC machines, width is X. This is also the case in the source code of the Onefinity Controller.
1 Like