After upgrading to v1.3.0 I have been unable to use my probe. It will get to the bit size verification but will not advance to the next step. Is anyone else having this issue?

If you are on 1.3 final and have probing issues. Please tag @DEV_D and they will contact you to assist.

[image] @DEV_D Onefinity Dev Team D Joined December 17, 2022

Hi @Pj77 , Can you please help us with the video which shows the issue of what you are facing along with version number and logs of the issue. Kindly send the details to developer@onefinitycnc.com Thanks!!

I loaded the official v1.3.0 and had a different probing issue. I used my half-inch bit again to do an XYZ probe. The first time I did it, all three worked fine. I tried it a second time. The Z probe went fine, then it went to the X probe, touched the block the first time, and just stopped wo…

Strange, my probe has worked everytime, without error since I went to 1.3. The only problem I had was after probing I had my probe touch each other on the side and my cnc lost home. [Craig] | Craig September 16 | | - | I loaded the official v1.3.0 and had a different probing issue. I used my …

Yeah, strange is right. I did some more testing: Rebooted and then xyz’d the 1/2 inch 6 times - first time, the z axis touched the probed and then it stopped. The screen remained the same (probing in progress) and I cancelled. I tried it 5 more times and each worked normally. I switched to a qua…

Very strange, still I have never used a 1/2 inch bit either. Computers? Go figure!

Since installing 1.3 my probe intermittently does not finish, the screen shows it is still probing but the physical probing movements have completed. Sometimes i can cancel and try again. Sometimes it gives an error that it will not allow jogging while probing so I am forced to hit the e-stop to res…

Hi @JohnJohnJohn , Thank you for bringing this matter to our attention, and we appreciate your understanding. Our team is actively working on resolving the issue you’ve encountered. Please allow us some time to thoroughly investigate and address the issue. We are committed to providing you with a p…

@DEV_D Hi Dev Team, Along with the issue reported above, if the probe is successful, the software sets an incorrect X 0 and Y 0 after the probe, causing an error flag. [IMG_3921] [IMG_3919] Any thoughts? Many thanks, Matt

Xyz probe issue after upgrading to v1.3.0

Firmware (BB Buildbotics) (Discontinued)

OnefinityCNC (Onefinity CNC Official ✅) October 7, 2023, 2:38pm 19

Topic		Replies	Views
Xyz probe problem	6	455	June 8, 2023
XYZ probe is setting Z too deep Touch Probe	39	3446	March 27, 2026
XYZ probe routine location	12	1640	March 4, 2021
Upgraded the firmware, now probing is not working properly (solved, cannot probe a v bit)	4	564	September 20, 2022
Bit drags across material when XYZ probe for home Touch Probe	12	328	March 27, 2026

Xyz probe issue after upgrading to v1.3.0

Related topics