Y rail wires connect at the front then pass thru the tubes to the motors at the rear. Wires at the front are annoying. I would rather run the wires from the black box under the table directly back to the motors. Is there any specific reason for the wires to connect at the front?

Y rail wires at the front?

pootaholic (Dave Lethaby) August 9, 2021, 11:32am 2

You will more than likely have to mount your controller on the right-hand side of the bench to accommodate the reversal of the Y-axes.

Topic		Replies	Views
Steppers in the front How To	5	271	December 25, 2023
Motors in front question Assembly	5	707	December 25, 2020
Where are your Y Steppers? - Poll	2	418	May 10, 2022
Reversing Y axes on Onefinity X-35/X-50 (stepper motors to the front of the machine) Troubleshooting (X35/X50)	3	446	November 9, 2023
Moving Y-axis plug Assembly	2	595	April 15, 2023