To preface: I’m still trying to get my wasteboard set up installed, tram router and flatten the spill board; so I’m at the beginning stages and have had only one carve to create a through hole/T nut base layer to the spoilboard set up. Bought used and functioned before. I’ve also searched the forum …

As stated per the email follow up, latest software from Dec 2, 2022, v 1.2.1 wasn’t installed. Took care of it once updated.

Take a look through this faq: [image] Troubleshooting: Rail is getting hung, stuck, grinding, or moving in opposite direction Troubleshooting Rail is getting hung/stuck/grinding. Special notes to read before following each step: A rail getting stuck/hung is t…

Confirmed and upgraded software. Examined, plugged and unplugged wiring. Attempted homing machine after booting back up, same issue. Numerical values appear on controller screen, no physical movement to reflect on Z axis.

[image] Support: How to determine if a wire or motor is damaged Controller (Buildbotics) FAQ This faq is used by support to determine if a wire or motor is damaged, and how to identify each one. WARNING: DO NOT UNPLUG OR PLUG ANY WIRES IN WHILE THE CONTROLLER …

Z axis numerically responds/moves on controller, but doesn’t physically move

Original/PRO Series (Buildbotics) (Gen 1) Troubleshooting (X35/X50)

OnefinityCNC (Onefinity CNC Official ✅) March 6, 2023, 9:32pm 4

Topic		Replies	Views
Bad wire or software update needed? Original/PRO Series (Buildbotics) (Gen 1)	4	792	January 2, 2023
Z Axis Stuck and Won’t Home Troubleshooting (X35/X50)	19	1686	November 24, 2022
Z-Axis Troubleshooting Troubleshooting (X35/X50)	5	567	July 31, 2024
X-50 Buildbotics 1.6.6 won't home Z Controller (Buildbotics) Discussion	1	83	December 17, 2025
Z Axis Stepper motor doesn’t turn. Just vibrates Troubleshooting (X35/X50)	2	742	May 12, 2022

Z axis numerically responds/moves on controller, but doesn’t physically move

Related topics