Hello Have anyone tried this approach to mounting an 43mm spindle, AMD/Kress etc? It’s essentially just a colletring with ID=43mm and OD=80, clamped in the Onefinity 80mm mount. Terje [onefinity_spindle_holder] [onefinity_spindle_holder_cut1] [onefinity_spindle_holder_top] [onefinity_spind…

I have two Bosch 1/2” routers and would love to be able to use them on my Journeyman. If you come up with a finished design I would be happy to be your first customer

So I had some fun again tonight! This is a easy way for a 43mm mount. It uses a standard Openbuild 43mm mount, a standard 80mm Onefinity mount and two easy to make plates. It might need rotating to get to the power switch, as it is now, it’s offset 2.5 mm to get the mount flush with the front, 75 m…

This is a clever solution that can take advantage of the many 43 mm mounts available. It would not be difficult to find one that has the configuration/sizing you need, leaving as you mention, only two plates to mill and tap.

Hey Terje, good idea, good design and nice pictures again! One thougt: I think people who like such milling motors would appreciate it very much if there was a motor mount for the milling motors with quick tool change, like Mafell FM 1000 WS , the Mafell FM 1000 PV WS and the AMB milling motors wit…

I love that setup! Seems very logical & clean. I don’t see why that wouldn’t work. I sure wish those spindles were available is the US. So far I haven’t found any sources for it. Many of them are 220v, but there are some 110v variants available. I think their low RPM still starts at 10k like the Mak…

Good to know! Thanks Tom! :sunglasses:

So this is for you: 17 mm from center to back, but at 84mm length, they also have one with 47mm length. I don’t have the exact dimensions on the bottom plate but my guess would be 1-2 mm deeper then the 80mm mount, as I have illustrated here in green. If someone upload a dfx of the bottom plate I …

I so enjoy these creative solutions - nice find! It is cutting it close but ~1ish mm clearance is still a clearance (need to keep that area a no chip zone!). I like the 84 mm version, but it will limit Z travel, as it is very close to my double 80 mm mount experiment. The shorter version is close t…

Hey Tom, hey Bill @Machinist , [image] TMToronto: I believe Stepcraft USA sells one model - MM 1000 DI nice digital interface. Unfortunately you seem to pay more for it in the US than here in the origin country ( MM-1000 DI ). Unlike one might think, it has no ER collet , it’s this proprietary…

43mm Euro spindle

Spindle/VFD (Aftermarket/Unsupported)

TMToronto September 15, 2022, 1:01am 26

I believe Stepcraft USA sells one model - MM 1000 DI

Introducing the new Onefinity ELITE Series, Powered by MASSO

Topic		Replies	Views
80mm spindle mount Gallery	123	9256	November 15, 2022
Offer a 43mm Spindle Mount Option for the Elite Series Hardware	6	1811	March 1, 2023
Using the CNCDepot spindle, Z-20 gantry rework Spindle/VFD (Aftermarket/Unsupported)	19	1929	April 11, 2023
Introducing the new Onefinity ELITE Series, Powered by MASSO Announcements	130	18197	October 31, 2023
All your 80mm Spindle questions in THIS thread	24	6302	April 26, 2021

43mm Euro spindle

Related topics