For those of you already up and running with your cnc I would love your input and thoughts on how you would have built your table differently or how you would modify it. What lessons have you learned that a new customer might find helpful? If you built it again what would you change? Is a basic tabl…

Mike, I have the 44x64, no sagging so far (knock on wood). 3/4 ply on bottom, with 3/4 MDF on top, glued and screwed from underneath. Will most likely put a few braces in when the Journeyman arrives in a few months to ensure future proofing for sag. BTW, I decided to reverse the y rails, so I can d…

@Bumpski I have the 48 x 64 kreg table. I haven’t seen any sagging. I have 3/4 plywood base the 3/4 mdf attached on top of that. Then the mdf wasteboard and t track on top of that.

I didn’t know you can put a brace on those tables Thank you

Do you have pictures of your set up? I’m looking at the 44”x64” Kreg table as well

My order won’t be here until mid-September, but I have my son home from college right now, so I’m taking advantage of the help in building the table and moving things around in my workspace. My plan is 4x4x30 legs (3 on each side), 2x4 framing (flush with top and 3-4" up from bottom on which I’ll p…

Ok, so I got the table put together today. Still need to attach the 2nd MDF board and bottom shelf (only the back half, similar to Brudaddy’s build). Very anxious for the 1F to arrive, but I’m studying, reading this forum, and getting done what I can so I can hit the ground running. Used the dado …

Resurrecting this discussion- What features of your table do you love (or wish you had included)? Looking ahead, what other features should I build in to the table? Storage tray/rack for router bits? Wood storage? Slide out bottom shelf? Purpose built space for other tools? Open or enclosed base (…

[cnc_table] This is my table, ‘The Minimalist’. I already have a full woodworking shop in a single-car garage and needed to fit the CNC. I sold my drill press and then used the rest of my space as best I could. It is quite high - 42" which was a conscious decision. It makes it easier for me to do…

Regarding dog holes, a guy at our Makerspace added some schedule 80 PVC blind holes and short pieces of PVC for locating holes in our makerspace CNC. Naturally, cheap AND will not trash bits that plow into them!

Cnc Table Hindsight 20/20

Gallery

Techrise (Noble Design) August 18, 2021, 10:19am 60

Just wanted to share a post by @Tanukizilla. He has a lot of advice for those of us getting started. New User to Aspiring/New Users

Topic		Replies	Views
Flip up CNC table Gallery	42	10615	May 11, 2021
The Table basic Original/PRO Series (Buildbotics) (Gen 1)	145	25219	April 9, 2025
CNC platform / table / enclosure Accessories	122	17112	November 3, 2022
Thoughts on my table design? Machine Setups	24	3420	October 10, 2022
New User to Aspiring/New Users Original/PRO Series (Buildbotics) (Gen 1)	18	2936	December 3, 2021

Cnc Table Hindsight 20/20

Related topics