i just upgraded to a 1.5kw spindle and i was looking in vcarve for a section to tell it i have a spindle not a router to control my speeds am i overlooking it?
David, if all the stars are in alignment, (VFD setup for Modbus, cabling to VFD Comm port, break out port connected, and Onefinity set to spindle), M3S16000 should turn the spindle on at 16000 RPM. Your Vectric tool database is where the Sxxx number gets attached to your tool path Gcode. Numerous post on the Modbus configuration, a little different depending on your VFD.