Flashed Lastest Firmware and comms with my VFD has been impacted

[Aiph5u (Aiph5u (not affiliated with Onefinity))]

Hey Andy,

@AndyP

Gymnastics!!: you have the correct image; dusty back from lying on the floor, strained neck muscle from checking and double checking cabling.

I enjoy that very much too everytime just have to replace a few hard disks on the computer that is the lowest been avoiding for days already

Regarding CNC Controller, I plan to put it next to the VFD control cabinet, would be good for you too at the moment, if it was next to your VFD . But I know, the Onefinity cables

@AndyP

what might be interesting to share is that the returning VFD speed to the controller is not 0 (whether running gcode or idle) but some random 2-digit number around 54 rpm. It varies +/- 4 rpm but essentially a stable number. Makes me think the controller is getting a rogue signal.

This seems as there is a bad noise over the signal, but the connection is a balanced connection, so it’s rather a bad contact on the connectors I would think. Or a chip failure, be we won’t hope that!

PS: If you put the old SD card in, save a configuration! That avoids typos when screenshooting and re-entering settings.

Food call 2 received, have to leave shortly!