Freeze up on start up

[OnefinityCNC (Onefinity Support)]

How To Remove All Gcode Files Manually (Fix for stuck file)

How to remove all gcode files manually. This process is used for when you see a stuck file. In 99% of cases, a incompatible file was loaded (such as the design file) and not gcode. The controller can read files labeled .nc, .ngc, .gcode. After running the below instructions, ensure you update to 1.0.9 firmware (or later) and the controller will prevent incompatible files from being able to be uploaded. These instructions are intended for scenarios where, for some reason, the controller bec…