I have encountered an issue where my woodworker makes a grinding noise and shuddering action partway through a toolpath. After the noise, the toolpath is offset as if it has lost coordinates. I have slowed my feeds down as low as 60ipm and am only taking a 1/16 inch cut with a 1/8 DCbit when this is…

Grinding Slipping Noise

blaghislain (Ghislain Blanchette) April 7, 2021, 3:57pm 3

I have the same issue when circular interpolation is not enable.

1 Like

Topic		Replies	Views
Bad sounding noises with a small spiral ramp toolpath Troubleshooting (X35/X50)	3	676	April 9, 2022
Fusion 360: "alignment" problem in CAM Fusion 360	10	1732	August 5, 2022
Fusion 360 and Circles (arcs) (circular interpolation) Fusion 360	9	3735	February 19, 2022
Grinding on X-axis- Yet, fine when jogging- Update #2 (solved with updated motor resolution settings)	19	314	October 29, 2024
Knocking (motor skipping steps?) doing simple Fusion 360 Bore operation and no bit in router Troubleshooting (X35/X50)	6	636	January 5, 2024