How to fix ERROR: X axis is greater than soft limit message

[MustCreateThings (Mike Tracz)]

I had a similar issue, and it was due to a lead in setting on Fusion 360. Here is a link to a write-up to explain. I hope this helps.

For those of you getting a soft limit error when maxing out your cutting area - Check this out (fusion 360 only)

So I’ve come across this while setting up my wasteboard surfacing program and again today when trying to run a bunch of parts from a 48" x 32" piece of plywood. I was getting a soft limit error on my Y-axis and it was from a ‘lead in’ feature as part of a 2D pocket in Fusion. You can see this below. [image] The lead-in and lead-out were happening outside of the workpiece therefore outside of the limits. By unchecking these boxes the toolpath will stay within the boundaries. [image] [imag…