when p press home it sets the router however nothing else moves.

Did it work before and stopped working or is this a new setup?

it has never worker new machine

I would suggest checking the cabling connections to the controllers and the steppers to ensure you have them fully seated in the correct locations. The connectors on the controller are grouped close together and you may have them plugged in the wrong locations. If you haven’t come across them alre…

Derek, I can move the machine all over the place with the joy stick just gives me shit when I try to home so I can do my spoile board.

Did you try adjusting the voltages for stall homing? There an official Onefinity video for adjusting stall homing.

I believe it had me adjusting amps, the term was max soft limit they started out as "0"s. As for the video if I had it here it would have been worn out from watching it so many times. Nowhere does it state stall homing though. Dave Happiness is having some to love, and share you life with…

I changed the currents back to 0 on Y, and upped the voltage from 2.2 to 2.3 Homed the machine and Y did not move. Dave Happiness is having some to love, and share you life with…

You are correct. I believe it is amps. I’m having a little trouble following what you said in your comments though. I assume this is the video you watched? [Adjusting Stall Homing On The Onefinity CNC] Assuming that’s the video I’m not really sure what to tell you from there. I’m a n…

[image] Gwdave: I changed the currents back to 0 on Y You set the stall current to 0 amps? The default is 1 amp… [image]

If you have followed the stall homing video correctly and still no-go on homing but can move to all corners via game controller, I would re-flash the SD card and start from a fresh software install. the software and how to videos are available in the forums, perform a search.

I have a woodworker that I cannot home. I have been trying for the past week to get it running with no luck

CommunityUser5 February 13, 2024, 4:06pm 12

Hey David,

did you consider this:

Stall Homing and the inability to work correctly when started at the opposite ends of the axis

Topic		Replies	Views
Help! Journeyman Homing issues Troubleshooting (X35/X50)	24	3259	February 26, 2022
Stall Homing and the inability to work correctly when started at the opposite ends of the axis Stall Homing (BB Controller) (FAQ)	0	1520	March 7, 2022
X Axis issues not homing correctly	16	3086	May 29, 2023
Machine cutting, everything stops. Resets X,Y,Z to zero and says the machine in not homed	7	669	February 25, 2023
Homing problems Troubleshooting (X35/X50)	20	4833	May 27, 2023

I have a woodworker that I cannot home. I have been trying for the past week to get it running with no luck

Related topics