It on, no it’s off, no it’s on just kidding

Machines (Original/PRO) Troubleshooting (X35/X50)
1

This is brand new and I checked re chechecked and reeechecked my cables. Not sure of the cause here but my monitor goes on and off during the middle of a carve. When It’s done, the monitor stays on. Any ideas here?

2

Seems like EMI from the router/spindle is affecting the monitor, it seems to be a common issue. There are many threads on the forums here about adding ferrite cores to the cables:

There are many more if you search for ferrite cores

1 Like
3

@WaywardWoodworker thanks for the tip! I’m going to get some EFI coils and hopefully that will be the fix!