Lightburn Device Profiles.
Use the following to set up your laser in Lightburn.
Under ‘devices’ page, click import. Then select your corresponding size.
Redline/Realtime Controller (Gen 2/Gen 1 using RedlineController & Apprentice)
-
Apprentice | Apprentice Redline.lbzip (1001 Bytes)
-
Woodworker | Gen 2 Elite Redline Woodworker.lbzip (1018 Bytes)
-
Journeyman |Gen 2 Elite Redline Journeyman.lbzip (1.0 KB)
-
Foreman | Gen 2 Elite Redline Foreman.lbzip (1.5 KB)
Masso Controller (Gen 1 Elite Machines)
-
Machinist | Onefinity Elite Machinist.lbdev (3.5 KB)
-
Woodworker | Onefinity Elite Woodworker.lbdev (3.5 KB)
-
Journeyman | Onefinity Elite Journeyman.lbdev (3.5 KB)
-
Foreman | Onefinity Elite Foreman.lbdev (3.5 KB)
Buildbotics Controller (Gen 1 Original and PRO models)
-
Machinist | Onefinity Original-Pro Machinist.lbdev (3.2 KB)
-
Woodworker | Onefinity Original-Pro Woodworker.lbdev (3.2 KB)
-
Journeyman | Onefinity Original-Pro Journeyman.lbdev (3.2 KB)
-
Foreman | Onefinity Original-Pro Foreman.lbdev (3.2 KB)
If you are manually creating a profile and not selecting a premade on from above, you must select choose GRBL-M3 (1.1e or earlier) for all Series machines.
